4 5
BLENDER
One Quart Capacity Specifications
•Ratings 120VAC-50/60Hz-singlephase
•Motors Permanentlylubricatedseries-wound
universal type
•Container 44oz.Polycarbonateor32oz.StainlessSteel
•Cord 6foot18gaugethreeconductorgroundingcordwith
strain relief
•cETLus 120Voltmodels
GROUNDING INSTRUCTIONS
•Foryourprotection,Waring
®
Commercial Blenders are equipped
with a 3-conductor cord set.
•120voltunitsaresuppliedwithamolded3-pronggroundingtype
plug and should be used in combination with a properly connected
grounding-type outlet, as show in Figure A.
If a grounding type outlet is not available, an adapter, shown in
Figure B, may be obtained to enable a 2-slot wall outlet to be used
with a 3-prong plug.
Referring to Figure C, the adapter must be grounded by attaching its
grounding lug under the screw of the outlet
cover plate.
CAUTION: Before using an adapter, it must be determined that the
outlet cover plate screw is properly grounded. If in doubt, consult a
licensed electrician.
Never use an adapter unless you are sure it is properly grounded.
NOTE: Use of an adapter is not permitted in Canada
.
OPERATION
1. Put ingredients into container and cover it. Always add liquid
ingredients rst, unless otherwise specied in recipe. Do not ll
aboveMAXline.Plugtheblendercordintooutlet.
2. With the toggle switch in OFF position, place container on
blender. Be sure container is fully seated and that drive
coupling is properly engaged.
3. Thisblenderhas2speedsettings:HIandLO.Switchtoggleto
desiredposition.Tocrushice,useHIspeedsetting.
4. ThisblenderisequippedwithaPULSEoption.Holdtogglein
downpositiontoengagePULSEfunction.UnitwillrunonHI
speed until the toggle switch is released.
5. When nished processing, set toggle switch to OFF position.
6. Allow motor to come to a complete stop before removing
container from blender.
7. Note: Containers with removable bottoms have right-handed
threads. When reassembling, be sure rubber seal is positioned
between the container and the ange on the blade assembly.
IMPORTANT
HOT BLENDING INSTRUCTIONS
Tominimizethepossibilityofbeingscaldedwhenblendinghot
materials, the following precautions and procedures must be
observed.
1. Limittheamountofmaterialsprocessedto1/2pint.
2. Completely remove the center portion of the two-piece
containerlidbeforestartingmotor.(Thiswillallowventingofthe
Rubber Seal
Kommentare zu diesen Handbüchern